Pattern Corrections

Sometimes mistakes happen.  Let's just admit it - they do.  Despite all efforts, something gets overlooked, or added incorrectly and there you go - a mistake!  Rest assured, I make every effort to ensure they DON'T happen.  I have a slew of awesome testers (want to be one? Contact me!) that painstakingly sew each and every pattern and provide detailed feedback to give you the best, most accurate instructions possible.  But for those times when even the best of us mess up, here's the corrections page.  I thank you for your purchase of a Tamarinis pattern, and am truly grateful for your understand when that oops occurs!  Happy stitching!

Red Fat Eight (or equivalent in scraps):

• Cut (2) 2” strips (2” x 22”)

            o  Subcut (6) 2” x 6” rectangles (A1, B1, B3, C2, C4, F1)

White Fat Quarter (or equivalent in scraps):

• Cut (2) 2” strips (2” x 22”)

           o   Subcut (6) 2” x 6” rectangles (A2, B2, C1, C3,E1, F2)

Blue Fat Quarter (or equivalent in scraps):

• Cut (1) 2” strip (2” x 22”)

           o   Subcut (5) 2” x 4” rectangles (A3, A5, B4, E2, F3)

Yellow Fat Quarter (or equivalent in scraps):

• Cut (1) 2” strip (2” x 22”)

          o  Subcut (6) 2” x 4” rectangles (A4, B5, D1, D2, E3, F4)
Any patterns ordered after 4/29/16 will reflect the above corrections.  Apologies for any confusion.

Boho Bliss Block 5 (original version)
Cream Batik: Cut (16) 1" x 3 1/4" rectangles (instead of (16) 1" x 5" rectangles)
                    Cut (4) 3 1/4" squares, cut in half corner to corner 2x (instead of (4) 5 1/4" squares cut in half corner to corner 2x)
Blue Circle Batik: Cut (4) 3 1/4" squares, cut in half corner to corner 2x (instead of (4) 5 1/4" square in half corner to corner 2x)
Orange #1 Batik: Cut (8) 2 1/2" squares, cut in half corner to corner (instead of (4) 6 1/8" squares cut in half corner to corner 2x)

Boundaries
Cutting:  Fabric A Block 1 should be 1 1/4" x 10" rectangle, Fabric C Block 1 should be 3" x 7 1/4"

Cutting and Steps 1 and 10 have been corrected to reflect these revised sizes.  No change in yardages.

If you've already cut, don't fret.  Simply adjust your seam allowance at those steps to allow for the slight undersize!

Calm Winter Barn Version:
It was brought to my attention that the Winter Barn Panel is only 22 1/2" wide.  If using this panel, please make the following adjustments:

Eliminate the (2) Block 2 pinwheel blocks. First is to the right of Block 1 at the beginning and second is to the the left of Block 1 at the end of the top and bottom block borders.

Apologies for any confusion regarding the panel size.

Celebrate Mini Quilt
Fabric A 1 1/2" x 3" should read for Letter B A5, as should template (not A4)
Fabric F 1 1/2" x 1 3/4" should read for Letter BA3, as should template (not A5)
              1 1/2" x 4" should read for Letter BA4, as should template (not A3)
Christmas Cactus:
Materials:
Gold Fabric 1 yard 
Light Purple 1/3 yard
All patterns ordered after 4/12/15 will reflect the above correction.  Apologies for any confusion. 

Congrats Mini Quilt
Fabric C 2" x 2 3/4" should read for Letter O B4, not Letter R
              1 3/4" x 3 3/4" should read for Letter OB2, not Letter R
Contempo
Cutting:  Eliminate Fabric F (teal or yellow) 6 1/2" strip from cutting - yardage needed = 1/4 yard each

Dazzle
Fabric D - on cover should read 1 yard.  Pattern (inside) is correct
Fabric E: Cutting SHOULD read (3) 4" strips.

Deco
For Fabric C: (4) 1 1/4" strips, (12) 1 1/4" x 3 1/2" rectangles

Direction
For Option 2, you need (18) 5" squares from Fabrics A, B, C, D, F, G, H and I.  Fabric yardage is sufficient for this. 


Elementz (original version)
Block 4 Fabric F: (1) 1 1/2" strip SHOULD read (1) 1 3/4" strip, G6=B, G8=F, H6=F, H8=B
Block 5 Fabric A: (1) 2" x 6" (J6, K6) SHOULD read (2) 2 1/4" x 6"
Block 5 Fabric E: (1) 1 1/2" strip SHOULD read (1) 1 1/4" strip, (5) 1 1/4" x 7"
Lavender Fields Version Block 7: Paper piecing pattern is mis-marked.  Please follow the CUTTING directions for Fabric A.  N1/P1, N5/P5 and N7/P7 SHOULD read Fabric A, not Fabric G.
Block 8 Fabric A: (2) 2 1/2" strips, (8) 2 1/2" x 3 1/2" (Q1, R1)
                            (1) 1 1/2" strip
Block 9 Fabric F: 2 1/2" x 4 1/2" (S3, T3, U3, V3)
                            Make (1) copy of each pattern
Excavation
Fabric A - should read (4) 2" strips, not 2 (does not affect yardage - sufficient yardage is called for - just a typo!)

FAVORITE THINGS
The pattern BACK ONLY lists Fabric C and Fabric D yardages incorrectly.  They SHOULD read  Fabric C  1 1/2 yards, Fabric D 5/8 yard.  
All patterns shipped after 7/16/19 will reflect the above correction. Apologies for any confusion.

Fizz:
Block 9 - Step 1 - SHOULD read: Fabric C for Print 1.  The newly recolored version (in black/white/gray or brights) has been corrected.
Block 10 - units should be labeled B1/B2.

Framework
Page 5, Step 20 - Fabric C should be listed at 1 1/2" (as per the cutting instructions!).

Happy Mini Quilt
Fabric A - the 2 3/4" x 3" cuts are for Letter P B1
Fabric E - should read: (1) 2 1/2" strip

Homestead (Halloween AND Christmas version)
CRIB SIZE ONLY!!!
Fabric B (6) 2 1/2" strips
Fabric D (4) 2 1/2" strips
Fabric E (2) 2 1/2" strips

Horizons
The diagram on the top of page 2 has the segments labeled backward (as you are looking at the fabric side).  The good news - this does NOT impact the block construction, as all units are symmetrical.  However, if you need a reference, here is the corrected label image:









Jangle (only precutting affected is shown below)

Fabric A: should read 1 yd

Cut (6) 3 ½” strips (Block B, Block E, Block F, Block G)           

                        (4) strips reserved for Block F and Block G

                        Subcut: (2) 3 ½” x 6 ½” rectangles (Block C)

                                    (9) 3 ½” squares (Block A, Block B, Block C, Block E)
Fabric B: should read 

            Cut (5) 3 ½” strips (Block A, Block F)

                        (2) strips reserved for Block F

                        Subcut (8) 3 ½” x 12 ½” rectangles (final quilt assembly)

                                    (3) 3 ½” squares (Block A)

Fabric C: should read

            Cut (7) 3 ½” strips (Block A, Block G)

                       (2) strips reserved for BlockG

                        Subcut (7) 3 ½” x 12 ½” rectangles (Block A, Block B, Block E)

                                    (7) 3 ½” x 6 ½” rectangles (Block B, Block D, Block E)

                                    (10) 3 ½” squares (Block A, Block C, Block D)

Fabric D: should read 3/4 yd
            Eliminate the 3 1/2" strip

(40) 3 ½” x 3” rectangles (Block 1)

(40) 3 ½” x 2” rectangles (Block 1, Block 2)

Chart page 2 - for D/B, E/B and F/B units, make (60) each

IF YOUR FABRIC IS NOT A USABLE 42 ½”:

a)    (3) 6½” strips.  For this fabric only, cut strips along the selvedge.

i)      (1) 42½” x 6½” strip

ii)     (2) 24½” x 6½” strips (cut remainder into (6) 2” x 20 ½” strips for use in piecing middle border strips)

b)    (4) 2” strips (middle border). Sew all 2” strips together in sets of 3, along the short side.

     Subcut into: (2) 54½” x 2” and (2) 63½” x 2” strips

c)    (2) 7¾” strips. Subcut into (8) 7¾” squares (hourglass blocks)

IF YOUR FABRIC IS A USABLE 42 ½”:

d)    (2) 7¾” strips. Subcut into (8) 7¾” squares (hourglass blocks)

e)    (3) 6½” strips.

i)      (1) 42½” x 6½” strip

ii)     (2) 24½” x 6½” strips

f)     (8) 2” strips (middle border). Sew strips together in sets of 3, along the short side. Subcut into: (2) 54½” x 2” and (2) 63½” x 2” strips

Step 8 (From the black fabric) you need FOURTEEN squares, NOT twelve.
All patterns printed after 04/20/17  will reflect the above correction.  Apologies for any confusion.

Tartary 2
Tartary is easiest when stitched with non-directional fabrics.  ALL cutting is listed for non-directional fabrics.  However, THREE of the Forest Floor fabrics (those shown in Tartary 2) are directional.  (Apologies - was not aware the print ran opposite of what I thought!).  While I recommend letting those fabrics "lay on their sides", if you prefer to cut with the direction of the print, you can find alternate cutting directions by clicking the link below.  NOTE:  This will allow you to control the DIRECTION of the print, but the motifs may not line up when you join the smaller cuts.  Link to Alternate Directional Fabric Cutting for Fabrics C, E and F:  https://media.rainpos.com/2236/Alternate_Directional_Fabric_Cutting.pdf

To the Point
Cutting Corrections:
(1) 2 1/2"  x 5 1/2" should read:  (1) 2 1/2" x 5" (section 5)
(1) 2 1/2" x 3 1/4" should read: (2) 2 1/2" x 3 1/4" (section 11 affected)
(2) 2 1/2" x 2 3/4" should read: (1) 2 1/2" x 2 3/4" (due to above correction)
Diamond 19: 36 1/2" (Step 14.5 and Diamond Cutting Diagram) should read 37 1/2" (which means you'll only have 1" left over)
Typo - Step 1.2: should read "Sew (1) 6 3/4" x 2 1/2" background to (1) 2 1/2" x ......".  Cutting is listed correctly.
           Step 7.7: should read "Sew (1) 2 1/2" x 24 1/4" Diamond 13....".  Cutting is listed correctly,   Diagram has been corrected in future shipments.
Apologies for any confusion.  All patterns printed after 5/29/18 will reflect the above corrections.

Additional Edit: Background needed is 5 3/4 yards, not 5 1/2 yards.  IF you want binding the same as per the pattern, then you will need 6 1/2 yards background total.  
Apologies for any confusion.  All patterns printed after 12/30/18 will reflect the above corrections.

Tranquil
No changes necessary to precutting - typo for Diagram and instructions for Step 10 Fabric D HST.  Should read:
10.  Fold the Fabric D 4 ¼” HSTs in half along the long side and finger crease to mark the center;
All patterns printed after 05/08/18 will reflect the above correction.  Apologies for any confusion.

Tropical Punch
Black - 2 1/4 yds
Cutting for Black:
Should read: (12) 2 1/2" strips
Apologies for any confusion.

Whirly Gigs
You need a total of (28) 3 1/2" Fabric A squares.  You can cut them from the remainder of the 7 1/2" strip and the 6" strip.

Whorl
Fabric A - 5/8 yd required
If making the runner, you do NOT need Fabric H, I, J, K.  Fabrics H-K are for the table topper only.

Winter Woods:
Updated Pattern:
Page 3 #10 SHOULD READ Fabric D, not Fabric E.

Precutting:
Fabric C - not needed are the (2) 5 1/4" strips.

49. Now your forest is ready for the tree bark. 

Cut fusible to fit the (4) cut strips from Fabric I, and fuse to the wrong side of the material following the manufacturer’s instructions.